Features
Special Function Keys The 1, Q,A, and Z keys are used for special functions. Each of these keys, when used in combination with other keys, sends a message as shown on the face of the Q90D to the left of these keys, such as “Hello GA”.
Primary Function Keys The Primary Function keys activate the primary functions such as dialing, redialing, and sending messages. Keys F1 through F13, are described in the Primary Function section of this guide on Page 14.
Ring Flasher Both red and white incandescent lights flash when the Q90D receives incoming calls. Only the red light flashes when the Q90D is powered by batteries.
HI-SPEED Indicator Hi-Speed transmission is used when communicating with another Ameriphone TTY that has this capability. If both TTYs have Hi-Speed capability and are in Hi-Speed mode, the red Hi-Speed indicator light turns on and your call proceeds at the higher rate. If not, the Q90D automatically uses the normal transmission speed.
Cell Flasher Indicator This red light flashes to announce incoming calls when the Q90D is on STANDBY mode and attached to a cellular or mobile telephone.
Tiltable Display Screen The screen displays stored information and the current status of calls (e.g., ringing, busy, etc.) and conversation.
Signal Status Indicator This red light indicates that there is some activity on the telephone line such as speech,TTY or some type of sound.
MIC Indicator This green indicator light is on when the VCO microphone is active.
|